7 Tips Related to ACCO Brands (VPT5050A) 71" 1:1 Projector Screen
You may need the power supply board resoldered as I had the same problem. The guy listed below can do it for you as I shipped mine from Illinois to him in California... Piece of cake getting the board...
Read MoreThe mitsubishi VZ5 chassis that will not power up often is the result of a leaky diode raising the voltage on IC700. A quick check is to check pin 4 of IC 700 for
0 Volts DC. If pin 4 has any voltag...
Read MoreFL231. FUSE.... The RCA ITC22 chasis has a common problem. and it not all that difficult to repair. Does your rca projection tv have read blue and green shadows? Does it have bowing in affect on the t...
Read More1. Try this - hold the menu button down for 10 seconds. TV should power up; you
will have to turn off front panel buttons on menu.
2. You can also try plugging in the TV through the USB on its...
Read MoreI ALSO HAVE A 52 INCH RCA (2 YEARS OLD) I HAVE TRIED ALL OF THE TIPS THAT HAVE BEEN DISCUSSED. LUCKILY I PURCHASED THE EXTENDED WARRANTY ON THIS UNIT.. AFTER A MONTH OF OVER THE PHONE TROUBLE SHOOTIN...
Read MoreIf your Magnavox TV powers on but has no audio or video check out the repair tips and kits at www.magnavoxhelp.com
Read MoreWanted to share my experience solving a convergence issue on my PT-51HX42 (other Panasonic rear projection sets are similar).Red convergence was way off one day, and doing some research, I discovered...
Read More